Najważniejszy jest fragment podsumowania:
When iron powder cores are used in low pass filters, the stop frequencies are usually harmonics of the fundamental frequency and therefore at a lower level, so that relatively small cores can be used in the filter inductors. As a guide the following size cores are suitable for use in hf transmitters from 1.8 - 30 MHz when used in output low pass filters. The important thing to remember is that the cores should never get very warm.
T-37-( ) 10 Watts max.
T-50-( ) 50 Watts max.
T-68-( ) 100 Watts max.
T-106-( ) 500 Watts max.
Zależność czy T-50 mogą przenieść większą moc niż 50W, będzie zależeć od produkowanych harmonicznych w nadajniku, a to sprawdzimy temperaturą - czy rdzenie nie są za bardzo gorące przy nadawaniu....
Jestem za płytką z rdzeniami na T-50.
When iron powder cores are used in low pass filters, the stop frequencies are usually harmonics of the fundamental frequency and therefore at a lower level, so that relatively small cores can be used in the filter inductors. As a guide the following size cores are suitable for use in hf transmitters from 1.8 - 30 MHz when used in output low pass filters. The important thing to remember is that the cores should never get very warm.
T-37-( ) 10 Watts max.
T-50-( ) 50 Watts max.
T-68-( ) 100 Watts max.
T-106-( ) 500 Watts max.
Zależność czy T-50 mogą przenieść większą moc niż 50W, będzie zależeć od produkowanych harmonicznych w nadajniku, a to sprawdzimy temperaturą - czy rdzenie nie są za bardzo gorące przy nadawaniu....
Jestem za płytką z rdzeniami na T-50.
Piotr, SP9LVZ